AUTONET TV

The Last Gas (Fuel Pump Replacement).

You're heading down the road and you notice your vehicle is sputtering, like it's running out of gas.  But the gauge show's it's still got a quarter of a tank.  So what gives?

It could be that your fuel pump is failing, meaning your engine is not getting enough gas to run properly.  While fuel pumps are built to last a long time, sometimes they fail.  Other symptoms you may have a bad fuel pump include your vehicle stalling and then refusing to start again, the engine overheating or a hum or whirr coming from around the gas tank.  Or, your Check Engine light may come on.

Most fuel pumps are in the gas tank. They have a small electric motor in them.   When you bring your vehicle to our service center, a technician will run tests to confirm the fuel pump is getting power to it but has failed.  Some vehicles have an access panel so the fuel pump can be removed and replaced. 

But in some vehicles that don't have that access panel, the technician has to drain the fuel and take the tank out of the vehicle to be able to replace the fuel pump inside.  Some parts such as brackets that attach the pump can be reused when the new fuel pump is installed.  Most technicians will recommend replacing the fuel filter at the same time the fuel pump is changed out.

If the technician has to remove the fuel tank, they'll also check for rust and corrosion and replace any affected parts.

Keep one thing in mind - your vehicle's fuel pump is in the fuel tank because it's kept cool and lubricated by the gasoline in the tank.  Try not to let your fuel level go below a half or quarter of a tank to maximize the life of your fuel pump.  Also, try to use Top Tier gasoline that has higher standards than some other fuels.  Your engine—and fuel pump—will thank you.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Them's the Brakes (Brake Rotor Resurfacing)

Your vehicle's brakes wear out.  It's inevitable. You'll notice it when you step on the brake pedal and feel it harder to stop, or there's vibration when you are braking. 

Most modern vehicles have disc brakes that each use a brake pad that press on a disc (disc brakes!) called a rotor.  The friction between them enables you to stop, and each time you do a little bit of the pad and the rotor wears down.

The original brakes on vehicles used a rotor that was thick enough to last through at least two replacements of the pads.  But vehicle manufacturers who want to save costs and weight now make them thinner, and sometimes the rotors have to be replaced after the first pad replacement.  But not always.

Vehicle manufacturers specify a minimum thickness to provide safe braking.  Sometimes rather than having to have your rotors replaced, they can be put on a lathe and resurfaced.  In other words, the surfaces of the disc can be slightly shaved off so the surface is flat and doesn't wobble. 

Whenever you bring your vehicle in to have the brakes checked, the technician will measure the thickness of the rotors to see if they can be resurfaced without leaving them too thin for safe braking. If they can, with the right tools and skill, the rotors can be resurfaced.  If not, the rotors should be replaced. 

Discuss the options with your service advisor.  Our service center can recommend replacements that are designed to help stop your vehicle as well as or better than the vehicle's original rotors.

Either way, keep in mind that keeping your brakes in top condition can supply the margin of safety that may one day save your life or the lives of those around you.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Stopping "Brake" Downs (Brake Pad Replacement)

If someone tells you to put the brakes on something, you know it means stop.  And stopping is one of the most important safety maneuvers you can do in any vehicle.  That means your brakes have to work properly. 

Let's face it.  You stop dozens of times every time you drive.  And over time, that takes its toll on your brakes.  Friction is what stops your vehicle.  Most newer vehicles have disc brakes, and the parts that wear out the fastest are those that rub against each other every time you stop, the rotors and the pads.

The rotors are discs that rotate with the wheels, and the pads are removable surfaces that make contact with the rotors to slow or stop your vehicle.  Bits of both wear off each time you stop, and when enough of either (or both) lose too much material, your brakes become unable to safely slow or stop your vehicle. 

The pads usually are the parts that wear out first.  Signs that your brakes might be getting worn are:

• You hear grinding, squeaking, or clicking when you apply them
• It takes a longer distance to stop
• Your pedal vibrates when you brake
• The front of your vehicle pulls to one side when you brake

If you notice any of these, bring your car to us so we can have a technician inspect your brakes. Most brake pads have a wear indicator that indicates it's time they should be replaced.  The technician who is checking things out will also look at your rotors for wear, as well as other brake system components.

With regular inspections and maintenance, you'll be sure that when you need to stop, your vehicle will be up to the task.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Stopping "Brake" Downs (Brake Pad Replacement)

If someone tells you to put the brakes on something, you know it means stop.  And stopping is one of the most important safety maneuvers you can do in any vehicle.  That means your brakes have to work properly. 

Let's face it.  You stop dozens of times every time you drive.  And over time, that takes its toll on your brakes.  Friction is what stops your vehicle.  Most newer vehicles have disc brakes, and the parts that wear out the fastest are those that rub against each other every time you stop, the rotors and the pads.

The rotors are discs that rotate with the wheels, and the pads are removable surfaces that make contact with the rotors to slow or stop your vehicle.  Bits of both wear off each time you stop, and when enough of either (or both) lose too much material, your brakes become unable to safely slow or stop your vehicle. 

The pads usually are the parts that wear out first.  Signs that your brakes might be getting worn are:

• You hear grinding, squeaking, or clicking when you apply them
• It takes a longer distance to stop
• Your pedal vibrates when you brake
• The front of your vehicle pulls to one side when you brake

If you notice any of these, bring your car to us so we can have a technician inspect your brakes. Most brake pads have a wear indicator that indicates it's time they should be replaced.  The technician who is checking things out will also look at your rotors for wear, as well as other brake system components.

With regular inspections and maintenance, you'll be sure that when you need to stop, your vehicle will be up to the task.

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903

Shifty Letters PRNDL (Transmission)

You probably figured out those shifty letters.  They're what you see on your automatic transmission shifter and stand for Park, Reverse, Neutral, Drive and Low.  Your automatic transmission is one of the great automotive inventions; here are some ways you can keep yours working well.

Maintain your transmission regularly.  A technician will check your transmission fluid's level and even its appearance and smell.  If it's dark or has an unusual odor, that could be a sign of trouble.

Change from one transmission direction gear into another only when your vehicle is stopped.  So many drivers want to switch from Reverse to Drive quickly or the other way around.  If you do that when the vehicle is moving, you can damage your automatic transmission.

Keep your vehicle's cooling system in top shape.  What does the cooling system have to do with the transmission? It helps keep the transmission fluid from overheating. 

Follow the manufacturer's recommendations for maintaining your transmission.  Some recommend at least an annual checkup by a trained technician. 

Let your powertrain warm up a little before overtaxing it. Especially in cold weather, don't step on the throttle too aggressively before all components are warmed up.  That way both your engine and transmission will last longer.

Transmissions can be costly to fix.  If you treat your powertrain with respect and regularly maintain it, you'll not only avoid expensive repairs, but you’re also much less likely to find yourself stranded because of a transmission problem. 

All Things Automotive & Diesel Service
1997 Walton Ave #C
Idaho Falls, ID 83401
208-523-3903